Convert inch of water column to foot of water column
1 in w.g. = 0.08333333332 ft H₂O
| microbar | 2,490 μbar |
| barye | 2,490 Ba |
| millitorr | 1,870 mTorr |
| pascal | 249 Pa |
| millimeter of water column | 25.4 mmH₂O |
| pound per square foot | 5.2 lb/ft² |
| centimeter of water column | 2.54 cmH₂O |
| hectopascal | 2.49 hPa |
| millibar | 2.49 mbar |
| torr | 1.87 Torr |
| millimeter of mercury | 1.87 mmHg |
| inch of water column | 1 in w.g. |
| kilopascal | 0.249 kPa |
| foot of water column | 0.0833 ft H₂O |
| inch of mercury | 0.0736 inHg |
| pound per square inch | 0.0361 psi |
| meter of water column | 0.0254 m H₂O |
| decibar | 0.0249 dbar |
| kilogram-force per square centimeter | 0.00254 kgf/cm² |
| bar | 0.00249 bar |
| atmosphere | 0.00246 atm |
| megapascal | 0.000249 MPa |
| kip per square inch | 0.0000361 ksi |
| gigapascal | 2.49e-07 GPa |
| million pounds per square inch | 3.61e-08 Mpsi |
inch of water column: This is a very small pressure, about 1/28 of a psi, and its smallness is the point: a whole air handling system might operate at 2 in w.g. Confusing it with psi overstates duct pressure by a factor of 28. Note also that natural gas appliance manifold pressure is typically 3.5 in w.g. and propane 10 to 11 in w.g., so the unit is what a manometer on a gas valve is actually reading. Full definition →
foot of water column: Head in feet of water is only equal to pressure when the fluid is water. A centrifugal pump develops a head in feet that is nearly independent of fluid density, but the pressure it produces is proportional to density, so pumping a fluid of specific gravity 1.3 gives 30 percent more pressure for the same head. Also check the reference temperature: values quoted at 39.2 °F, 60 °F and 68 °F differ in the fourth digit. Full definition →
Multiply by 0.08333333332 to go from inch of water column to foot of water column, or divide by it to go back. Every conversion on this site routes through the SI value (Pa) rather than a table of pairwise factors, so a round-trip returns exactly what you started with.
Going the other way? foot of water column to inch of water column: 1 ft H₂O = 12 in w.g..
| 1 in w.g. | 0.083333333 ft H₂O |
| 2 in w.g. | 0.16666667 ft H₂O |
| 3 in w.g. | 0.25 ft H₂O |
| 5 in w.g. | 0.41666667 ft H₂O |
| 10 in w.g. | 0.83333333 ft H₂O |
| 15 in w.g. | 1.25 ft H₂O |
| 20 in w.g. | 1.6666667 ft H₂O |
| 25 in w.g. | 2.0833333 ft H₂O |
| 50 in w.g. | 4.1666667 ft H₂O |
| 75 in w.g. | 6.25 ft H₂O |
| 100 in w.g. | 8.3333333 ft H₂O |
| 250 in w.g. | 20.833333 ft H₂O |
| 500 in w.g. | 41.666667 ft H₂O |
| 1000 in w.g. | 83.333333 ft H₂O |