Convert foot of water column to inch of water column
1 ft H₂O = 12 in w.g.
| microbar | 29,900 μbar |
| barye | 29,900 Ba |
| millitorr | 22,400 mTorr |
| pascal | 2,990 Pa |
| millimeter of water column | 305 mmH₂O |
| pound per square foot | 62.4 lb/ft² |
| centimeter of water column | 30.5 cmH₂O |
| hectopascal | 29.9 hPa |
| millibar | 29.9 mbar |
| torr | 22.4 Torr |
| millimeter of mercury | 22.4 mmHg |
| inch of water column | 12 in w.g. |
| kilopascal | 2.99 kPa |
| foot of water column | 1 ft H₂O |
| inch of mercury | 0.883 inHg |
| pound per square inch | 0.434 psi |
| meter of water column | 0.305 m H₂O |
| decibar | 0.299 dbar |
| kilogram-force per square centimeter | 0.0305 kgf/cm² |
| bar | 0.0299 bar |
| atmosphere | 0.0295 atm |
| megapascal | 0.00299 MPa |
| kip per square inch | 0.000434 ksi |
| gigapascal | 0.00000299 GPa |
| million pounds per square inch | 4.34e-07 Mpsi |
foot of water column: Head in feet of water is only equal to pressure when the fluid is water. A centrifugal pump develops a head in feet that is nearly independent of fluid density, but the pressure it produces is proportional to density, so pumping a fluid of specific gravity 1.3 gives 30 percent more pressure for the same head. Also check the reference temperature: values quoted at 39.2 °F, 60 °F and 68 °F differ in the fourth digit. Full definition →
inch of water column: This is a very small pressure, about 1/28 of a psi, and its smallness is the point: a whole air handling system might operate at 2 in w.g. Confusing it with psi overstates duct pressure by a factor of 28. Note also that natural gas appliance manifold pressure is typically 3.5 in w.g. and propane 10 to 11 in w.g., so the unit is what a manometer on a gas valve is actually reading. Full definition →
Multiply by 12 to go from foot of water column to inch of water column, or divide by it to go back. Every conversion on this site routes through the SI value (Pa) rather than a table of pairwise factors, so a round-trip returns exactly what you started with.
Going the other way? inch of water column to foot of water column: 1 in w.g. = 0.08333333332 ft H₂O.
| 1 ft H₂O | 12 in w.g. |
| 2 ft H₂O | 24 in w.g. |
| 3 ft H₂O | 36 in w.g. |
| 5 ft H₂O | 60 in w.g. |
| 10 ft H₂O | 120 in w.g. |
| 15 ft H₂O | 180 in w.g. |
| 20 ft H₂O | 240 in w.g. |
| 25 ft H₂O | 300 in w.g. |
| 50 ft H₂O | 600 in w.g. |
| 75 ft H₂O | 900 in w.g. |
| 100 ft H₂O | 1,200 in w.g. |
| 250 ft H₂O | 3,000 in w.g. |
| 500 ft H₂O | 6,000 in w.g. |
| 1000 ft H₂O | 12,000 in w.g. |